KLEIB Arctic White is a snow-white, anti-reflective latex pain designed for decorative painting of walls and ceilings indoors, with exceptional stain-resistant properties and reduced susceptibility to dirt. A deep matt paint with low reflectance and high coverage. Particularly recommended for painting ceilings, as it visually masks imperfections in the substrate. Creates anti-reflective, perfectly white coatings, without visible streaks. The no-splash formula and optimum drying time make it easy to paint even the most difficult surfaces. The paint has superior resistance to washing and wet scrubbing. KLEIB Arctic White can be used on cement and cement and lime plaster, gypsum substrates, plasterboard, paper and fiberglass wallpaper.

The working surface should be clean, dry, compact, uniform, free of grease and dust. Scratches and deficiencies should be repaired and filled in. The paint is recommended to be applied on strong, compact substrates. The surfaces to be painted should be dusted off thoroughly and then washed with water. Walls painted with chalk based paint and flaking working surfaces should be washed, then deep penetrating KLEIB G2 primer should be applied. We recommend priming plasterboards with KLEIB G1 before painting. It is particularly important to prime board joints and areas partially covered with gypsum mortar, as the use of KLEIB G1 primer equalizes the absorbency of the working surface and prevents streaks when painting. Note: It is recommended to paint a given area using paint from the same production series (date), under the same conditions and in the same fashion.

The paint is supplied ready to use. It may not be combined with other materials. After opening, mix thoroughly the contents of the bucket until a smooth uniform consistency is obtained.

The paint should be applied in two coats. When applying the first primer coat, the paint can be diluted up to 10% with water. The paint should be applied at an air and working surface temperature of +5°C to +28°C. Subsequent coats are recommended to be applied after at least 4 hours. Paint plasters after 6 weeks of curing or after the time indicated by the manufacturer of a particular plaster, finishing plaster, putty. General wall paint technology should be maintained. We recommend using a microfiber paint roller or natural bristle roller with a minimum pile height of 12 mm.

The paint should be stored and transported in tightly closed tubs in dry conditions and plus temperatures from +5°C to +28°C, away from sources of heat. Protect from overheating. Note: Water-based product. It is permanently damaged when temperatures fall below freezing. Do not leave containers open once they have been started. The shelf life is 24 months from the date on the packaging. The product is not classified as hazardous under the current ADR Agreement. Covered car transport required.